L298N Motor Drive Controller Board Modul Dual H-Brücke DC Schrittmotor Treiber für Arduino Raspberry Pi Smart Roboter auto

Notice * L298N h-bridge motor controller working mode creates higher working efficiency, L298N as main chip, ST corporation production. Can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors. * To avoid damage the voltage stabilizing chip, please use an external 5V logic supply when using more than 12V driving voltage. * Use large-capacity filter capacitors and diode with freewheeling protection function, increasing reliability. * Our motor regulator board drive voltage is 5V-35V, drive current is 2A, max power is 25W. * Large capacity filter capacitance, afterflow protection diode, more stable and reliable. Parameter * Chip: L298N * Logic voltage: 5V * Logic current: 0mA - 36mA * Storage Temperature: -20 ℃ to ℃ to + 135 * Operating mode: H-bridge driver (dual) * Drive voltage: 5V - 35V * Drive current: 2A (MAX single bridge) * Maximum power: 25W * Dimensions: 43 x 43 x 27mm Product features 1.L298N as main driver chip makes strong driving ability/small heating/strong anti-interference 2.Use large-capacity filter capacitors and diode with freewheeling protection function, increasing reliability 3.This module integrated with one internal 5V power supply, meaning when your driving voltage is 7V-35V, it makes 5V of energy board power supply logically; when 5V of energy board power on, please not input voltage to +5V power supply in interface but you can lead 5V voltage for external usage. Eg: ENA enable IN1 IN2 to control OUT1 OUT2 ENB enable IN3 IN4 to control OUT3 OUT4